Ihr Warenkorb ist leer
Ihr Warenkorb ist leerKunde
Bewertet in Deutschland am 13. April 2023
Das Gewinde passt nicht zum europäischen 3/4 zoll Gewinde.
Olbermann H.
Bewertet in Deutschland am 23. September 2022
An diesem Gerät fehlt eine Feststellbefestigung so dass bei einem Schlauchanschluss für ungeschickte eine 3. Hand benötigt wird
Werner R.
Bewertet in Deutschland am 22. Januar 2022
Die Anschlüsse and beiden Seiten sind tatsächlich nicht 3/4 Zoll Verschraubungen. Die Gewindesteigungen passt nicht! Es gibt dennoch Möglichkeiten dieses ansonsten gute Produkt zu verwenden, denn die Anschlüsse im Filter selbst sind ordnungsgemäß 1/2 Zoll. Dafür muss man aber zusätzliches Material besorgen. Ich habe es so gelöst, dass ich anstatt dem AG Anschluß am Filter eine Reduktion 3/4 Zoll AG auf 1/2 Zoll AG verbaut habe. Damit ich auch eine Verschraubung habe, verwendete ich diesen AG Anschluß vom Filter jetzt zusammen mit der IG Überwurfmutter vom Filter auf der anderen Seite (diese passen nämlich, obwohl nicht 3/4 Zoll, zusammen). Dann hat man dort 1/2 Zoll und macht damit weiter oder besorgt noch eine Reduktion 1/2 Zoll IG auf 3/4 Zoll IG oder AG je nachdem was man braucht. Alternativ könnte man nur den Filter ohne die "falschen" 3/4 Zoll Anschlüsse verwenden und auf beiden Seiten direkt mit den 1/2 Zoll AG Anschlüssen am Filter arbeiten.
JF Farquhar
Bewertet in Großbritannien am 21. Oktober 2021
This filter was bought to prevent debris from raw springwater from clogging up a cistern ball valve. It is a reasonably good quality item but the threaded brass fittings are not 3/4" BSP. These do however screw into 1/2" BSP threaded holes in the plastic filter body. Each is sealed by an O-ring, one of which had been trapped and shredded when the filter had been assembled in the factory. I removed both brass fittings and replaced each with a 15mm x 3/4" adapting female coupler (Screwfix ref. 38542). The 15mm compression nut and olive were removed from the couplers, leaving a male 1/2" BSP threaded stub that was screwed into the filter body and sealed with "liquid PTFE" (to avoid the additional stress that PTFE tape can exert). It was a bit of a bodge really but worked fine and the filter is now in service with no issues. Considering the reasonable price and quality I wasn't too bothered about having to do a bit of fettling but I wish I'd known when I ordered the filter as I could have bought the replacement fittings at the same time.
Produktempfehlungen